Plastic Vacuum Forming by Autofrost Address: Unit 1 / 9 Works Place, Milperra NSW 2214
Phone: 02 9774 4556
Tel: +61 2 9774 4133
Fax: +61 2 9772 3272
About Vacuum Forming
Vacuum forming - is basically thermoforming, whereby a sheet of plastic is heated to a forming temperature and stretched onto or into a single-surface mold. It is then held against the mold by applying vacuum between the mold surface and the sheet. The advantages of Vacuum Forming are relatively low cost tooling which makes it ideal for low volume products & prototypes. Autofrost is an Australian producer of Vacuum formed products and a specialist in vehicle requirements and projects which require a once off or prototype produced job. Autofrost are able to offer a low cost solution for all vacuum forming needs because they are the short run specialists. Contact Autofrost for more information.